Thanks Jeff, gives me a couple of ideas! David
Jeff: Do you have anymore information about the hood spring installation on that Maverick you have pictured? It looks like it was modified to...
These are the only custom strut hood hinges for our Mav/Comets, not cheap............
Are you installing F30 Spectra gas tank? Perhaps you can use this assemble on top of your tank and then connect the existing fuel vapor return...
Back in the early 90's when I installed Holley's Pro-Jection TBI kit on my 74 Comet, I used the existing fuel vapor return line (one that went to...
Other than me.......
I had that same clutch release fork with the "spring", was a pain in the butt to try and feed into the pivot bracket! I changed over to the "clip"...
The Holley pump ports are 3/8" NPT and I think the stock Ford fuel line from pump to carb is 5/16" uses 1/4" NPT? So you would have to purchase...
I've used this on my 65 Mustang in the past and will again put it on my 73 Comet, once it is put back together! Nice thing with this pump, you...
My 74 Comet did not have this override push button switch, yet my 74 Mav had it and both had that interlock box, weird! David
I remember unplugging and removing it from my 74 Comet, do not think I did anything else and it ran fine for over 20 years! Removed it because I...
Yup, that is what it is, the one in my 74 Comet was yellow.....you can disconnect and remove it, if you like. David
These would have worked, without drilling hole in side of shock towers..............
Smaller bore, easier pedal effort, but more travel, so pedal closer to floor. Larger bore, harder pedal effort, but less travel, so pedal is...
Roger: Tabs downwards and flat side facing towards the front, so frame mount in picture with tab down, is suppose to be on RH of car........mine...
If you like to download the T5 Service Manual............
As mentioned in thread above, Toploader input will not fit, it looks like the end of the T5 input snout was ground down shorter, all the inputs I...
I thought he said that was a T5 he had pictured in thread #16??? As for Toploader 4 speed main cases (RUG/HEH 28 or 31 splined), they are all the...
It is held by fork type clamp, loosen/remove bolt, either 5/16" or 3/8" , gently wiggle/pull out the metal housing/speedo gear, wrap in plastic...
Here are speedo cables from AutoKrafters: David
Separate names with a comma.
