Look at this, maybe it will help. http://www.joby.se/corvette/misc/firing_order.gif I believe it would have said that 5 and 7 are beside each...
Off topic but an old school SBC and a ford 302 have the same firing order. Chevy just numbers the cylinders differently than Ford.
Yes and no. Those are 65 Thunderbird tail light lenses but the bezels are from 1964 Thunderbird, no perpendicular chrome ribs....
My favorite pic so far..
That is what I am planning to do to mine. I talked to Thack about how he did his, doesn't seem like it would be too hard to do. Here is a pic of...
What is wrong with the hood? It looks fine to me :evilsmile
It is not the engine builder that is the problem, the company I bought the stroker kit from was suppose to balance it. The crank has holes drilled...
Alright i just swapped balancers with a friend of mine and got the same vibration. He has a replacement engine from autozone for his 69 mustang...
A little more info... I bought the rotating assy (347 ci) from a company on ebay, they sent me the balancer and flexplate as well. Neither of them...
A friend of mine has a balancer I am going to try to see if it works. I put a new input shaft in the trans when I rebuilt it (output shaft as...
I have a 69.5 and I don't think my stock hood had a hole for the prop rod either. My hood doesn't go up high enough to use the prop rod hole in...
Ok, I will try a different balancer and see if that fixes it...thanks.
There is no sound with the vibration, what you are describing is more of a rhythmic vibration. From my understanding those are usually caused by...
So the only way I would go about fixing it would be to tear the motor down and have it balanced at a machine shop? What would be the damage to...
High frequency meaning that the shifter knob is moving back and forth about a 1/16 of an inch a hundred times a second verses it moving an inch...
What does it feel like when you have the wrong balancer on the motor? I have a "high frequency" vibration that gets worse as the RPMs climb. It...
From what I have read, it is one inch wider overall but the perches are the correct width.
I have one of those consoles in my car too.
Even though the snap ring is in place the rear bearing may not be seated all the way? I had a really hard time getting that bearing on, I put it...
It was the instructions that came with the rebuild kit from David Kee that stated synthetic was not recommended. But like Paul said they also...
Separate names with a comma.
