May get by with the stock rockers if they are 3/8 stud, But you will need new hardened push rods to work with the heads (unless you already have...
Its all in how the big carb is tuned, B.G. sent a wet flow sheet with mine and it was over 1100 cfm, I can get 17+ mpg if i drive it rite. A...
I don't agree with it all, But there is some good info here about the spring clamps if you are interested in tuning the springs....
I didn't mean using the line, you need a bigger line as the vent line is to small. some say they have used the line, But i would be afraid it wont...
I to run a duel fuel system from the tank. My engine runs a BG mechanical pump (225 GPH). I use a Holley blue for the Nitrous with a Mallory boost...
I revised the drawing a little to maybe clear up some confusion. I had the gauge going to the wrong hole, Sorry.
Over the years dealing with Holley i have found they do a lot of things weird. I now try to buy anything but Holley if i can. After a 3000 dollar...
The problem is not the pump, Its the regulator. Those 19.99 dollar regulators that they send with the pumps cant flow enough fuel Thur it (dead...
I'm not trying to start a safety debate here but, I don't have all the necessary safety equipment (roll bar, fire system, etc.). But i to run...
I woke early thinking of your situation, I thought "what would i do?". Well i came up with this. Now mind you it is untested, I have used a...
Exactly, We use one as a return on the 671 and it works ok so far. In doing it this way the fuel doesn't go Thur the regulator to the carb(s)....
If that is a standard Holly regulator, the internal orifice is not large enough, I cant remember the exact size but have torn them apart before...
I'm not positive, But i think my NITROUS WORKS bottles have a 2500 psi blow off. I think its written on the valve on most bottles.
Most, not all systems is set up to run on 850 psi. This is usually the pressure where the NOS bottle heater turns off. I run mine at 1100 psi...
I actually use a second pickup out of the tank, But anything would be better than running out of fuel with 150 shot of spray spraying. A lot of...
Currie also makes a drop in 9 inch housing for the Maverick.
I don't like to feed the N20 off the same line as the carb gets. Because it will be impossible to flow the N20 plate with the carb at wot. ( i...
No as i have water separators on my equipment, And what do you figure is in the bottle now? After you clean your N20 filter the first time you...
Just be sure and make sure that you still use the inlet side as inlet. The solenoids use the PRESSURE to keep them closed.
I will say that if i were you, I would install the valve myself then pump up the pressure in the bottle as high as you can get it with air. If the...
Separate names with a comma.
