You have a rotted cowl...Sorry
Replace that fuel hose...NOW...Tighten the screws on the top of the carb(Just cinch em down don't gorilla them) Put a new fuel filter on it too,...
Where in buffalo are you??? I am in Cheektowaga. With a first hand look at it, I could tell you more...
If you have exhaust fumes in the car...You have an exhaust leak...Is the car loud??? Check entire system for rotted/perforated pipes...Leaking...
Post what you need in the parts wanted section...You will get replies to your needs....
https://www.summitracing.com/parts/brc-11096/overview/ This is what you need...
Get your self a good spot weld cutter...Your gonna need it. Do one side at a time and you wont have any problems.. These cars are more rigid than...
The headliner material is pinched behind the windshield weather strip. You are going to be hard pressed to remove the headliner without damaging...
A ford 302 V-8 engine is the easiest swap to do (If you want to go to a V-8)...Search the site/tech articles and you will find all the info...
Before you cut/weld anything...Fit the patches to the floor to be certain they will cover the damaged areas completely. Then you can mark off the...
Yes definitely wait and see Glenn...The car will be carrying more weight once its all together...It will sit differently than it does now. Oh by...
Procedure for you, will be to Remove water pump/ balancer/frt cover...Examine chain and gears...Turn crank and see if the marks on the gears line...
You need "Strut rod" bushings...Your local parts store should be able to hook you up with those...Do NOT buy poly urethane ones. Get factory...
If balancer is way off at TDC You may have a balancer that's slipped and no longer accurate. Be certain #1 is at TDC on the compression...
Don't need a timing light to verify mechanical timing...Pull #1 spark plug, install finger/thumb to block hole (A Helper is a good idea if you...
Did you replace all the rubber fuel lines??? I have seen plenty of neoprene/rubber bits in float bowls/ filters over the years. They usually show...
Put the arm in a vise(Or leave it attached to the column)...Heat the knob with a heat gun...Big pair of channel locks/pliers around the...
Yes we most definitely do Frank. No argument here...
Well...at least it has big brakes behind the big wheels...I do like the fender mounted mirrors though. (Of course I like old Toyota Celica GTs'...
Those rockers are on a shaft...Tighten the pedestal bolts down from front of engine to rear of engine. Torque bolts to 30 to 35 ft/lbs and your...
Separate names with a comma.
