and there was much rejoicing
I had read some other posts that people had experienced belt slippage when updating to higher amp alternators, so when I updated to a 3g 130 amp I...
It may be easier to get a mid 80's Mustang 5.0 HO dual snorkel air cleaner and fab some duct work. I will be attempting a factory type thing with...
How about the ignition module?
Belt squeal is the belt slipping on the pulley, WD40 will not improve that. You can start the car without the ps belt to see if it still squeals,...
After having done this, there is not much choice in vertical placement as the valance is narrow, and the horizontal location is dictated by the...
[ATTACH]
Diagrams indicate lt green & yellow were for the door switches and connect to the fuse panel and headlight switch. Possibly for an additional...
I used a BFS slid between the pedal and rod. They were like an old married couple and didn't want to be separated after 40+ years. [IMG]
Got the Mustang backup lights installed.
Your valve covers maybe old enough that there is a left and a right, I have not seen those in years.
The valve covers are identical. Typically the driver side does not have the pcv grommet installed and has either a screw on cap, or a push on cap...
Looks like the positive crankcase ventilation (pcv) valve. It can connect to the air cleaner, or to the intake manifold, or the carb. [IMG]...
Perhaps they were roller cam but not HO?
I would put it in line with the factory cooler, disconnect one of the tranny lines from the radiator and run that to the aux. cooler and then...
The problem may be your brakes or front suspension in that case.
I cannot answer you 100%. I have a 302 with a Stealth intake and it is 4 inches from the carb flange, where the air cleaner sits, to the bottom...
What are flip out windshield wiper arms?
Are those for the deck lid?
I believe there are a few here that have added the Mustang reverse lights to their car. If so would you possibly be able to post a picture? I...
Separate names with a comma.
