I had over 100.
That is the return line, Frank. You want the fuel to stay oriented in the hose the entire way so it is reversed.
It is this one: https://www.amazon.com/Industrial-Endoscope-YINAMA-Inspection-Waterproof/dp/B07RMXDS8L It is certainly cheaply made, but it has...
Can't wait for when I need to find something I dropped out of sight - it came with a hook and magnet attachment too!
I got a cheap boroscope as a gift this Christmas, while it is not super hi definition, it sure is handy for creeping around and checking out tight...
Agree with Tom. Get a vacuum gauge and tape it to the windshield, see what is going on while it happens.
@Jaybee - you got it!
Agree with above. Find something you like and replace it - you can even get custom emblems made for a reasonable price these days.
Been working on the fuel line routing. I originally was going to come straight across from the apron, but there is no strain relief in that...
Frank, if I'm being honest - no. The car has been sitting for so long I'll probably get everything running and driving before its worth doing the...
Finished up the two VaporGuard lines that run on the outside of the apron today. I took a gamble and ordered the NotchHead 2816-6 Braided Line...
Started working on the braided lines today and remember why I wanted to use the UltraPro hose before it went off the market - I'm terrible at...
Got a few parts down out of the attic and I'm a bit disappointed. My rear valence always had a few chips and cracks in the paint. When I removed...
I used my original '71 i6 springs with a full coil cut out to achieve this ride height back in the day: [ATTACH] Looks like yours will settle in...
Got some Gasiola E-Seal for Christmas to apply to my NPT fuel fittings. It's formulated for ethanol fuels but works fine for other blended...
Thanks. I've done it both ways - with a stock suspension and a foxbody style setup. The trim for the stock setup certainly gives you more knuckle...
Reasons to make sure you have everything in place during your mockup (I ordered an elbow):
It's a Wilwood Remote Tandem Master unit. I originally planned to use the screw-in billet reservoirs for it, but may go ahead and keep the plastic...
Mocked up the clutch master reservoir bracket today. Had to dig my wiring harness out to ensure it would clear without issue. Mounts to the two...
Finished cleaning up the tie down plates and bolts and re-installed. Now I can start on finishing the fuel line that runs in front of the driver's...
Separate names with a comma.
