The AOD in stock form is a power robber, it does give you over drive but it is not the most efficient! Once they are performance updated they do...
what you need to use is a flat plate under the carb to seal the gap! Edelbrock used to sell a flat steal plate to do the job, the Idea of a 2...
Good call! That is most likely the case Auto tranys don't like any kind of grindings
If your taking the tranny out of the car check the end play and make sure it is within spec, this is a critical thing in an automatic that...
Any body that thinks they will get better mileage with a 750 carb than a 600 is an idiot by any standards You can t give proof because it...
I have to agree with you Larry a 600 cfm carb is plenty carb for a mild small block engine It may be possible to see a power increase at...
I don't know what the heck has happened to Holley but there carbs are not the same take it out of the box and run it piece they once were....
MSD boxes never fail that is why every NASCAR racer have two box's set up ready to go! at the flick of a switch! I give away a complete MSD...
Every body has a right to his opinion I feel the same way about the MSD system When it works it works well but I can' afford to be buying...
The macpherson strut is not a good road race setup when Steve Salean raced mustangs he said there was no way to make the mustang go around...
I like a distributor that makes my engine run , The stock duraspark distributor would not fit into the engine because the manifold was in...
I use one of those on my 400 Ford not because I thought it was good but because The only two distributors that would fit My engine with the...
What would be nice would be a two door Wagon then make it in to a Ranchero with a 347 5 speed!
The clutch packs are loaded by oil pressure if the packs have to much clearance they can travel to far causing oil to bypass this will cause...
If you don't disassemble the packs it saves the hassle of having to shin them for clearance, The clutch pack shimming is important but is...
I seen the Comet never seen a Maverick! The thing I seen that is not seen vary often was the two Edsel Wagons !
If it is your slicks you can add air that will help, I found the old ripple wall slicks more forgiving than the new slicks I used to run...
There are guys that will disassemble and only replace what is needed then there are guys that charge for every piece the a they can sell you!...
You disassemble the clutch packs or leave them assembled? Good to Hear it worked out!
Separate names with a comma.
