I haven't experienced the effect the 4bbl is supposed to show since I installed the motor. It's been that way since day one. It had an over...
Haven't fixed the problem or found it. I've been searching for someone in my area that knows how to look for the solution. I'm limited as to what...
Not sure if this is relevant or not to my situation but I noticed when first cranking the motor when cold, the fuel pressure is at 6 1/2 to 7 lbs....
I don't recall the brand electronic ignition I purchased but it called for a coil that had at least 3 oms or it could damage the EI and therefore...
Well I've got a lot of input on things to check. Process of elimination. Thanks people.
Too bad you're in MN. We need more people with your knowledge everywhere.
Well I did swap out the points for an electronic ignition. I still have the points and condenser and coil from before. I could easily change that...
No. It was doing the same thing when it had the manual pump. That's the reason I took it to the repair shop.
I checked the pressure while in park. First of all, I'm only carrying around 3 lbs of pressure at idle and when punching the throttle, it bogs and...
Can I check the fuel pressure while in drive? Or does it need to be under a load? If needs to be under a load to get the correct reading, I can't...
I checked this morning for a crushed fuel line under the body and the line is good, However, with the vehicle not running, I removed the breather...
That's exactly how it does.
I'm going to check off a thing or two to start with. (Look for a crushed fuel line)(blow out the original steel fuel line and check for trash or...
It does not bog until I try to kick in the 4bbl. Normal acceleration it runs fine. Gets up and goes.
Not sure on the timing. That was set at the last shop it was in. The distributor is new as is everything on the motor. The 302 is a reman from...
The timing is set and there are no vacuum leaks. It runs fine until the secondaries are applied. Then it is as if it is running out of gas.
That's a thought. Something I hadn't thought of nor had anyone else that's looked at it. All lines are new with the exception of the main steel...
Well guys, I still haven't found the solution to the issue of my 302 bogging down when trying to kick in the 4bbl. I've had mechanics work on it...
I'm sure it's pressed on there or molded on. Just wondering if anyone had removed the knob and what level of difficulty they had, if any. I...
The column shifter on my 73 has a plastic knob and a metal arm.
Separate names with a comma.
