All I did was re-seal the brass float where it fastens to the arm. Cheaper than replacing the entire assembly.
I just had this happen. I pumped the tank down, removed the pick-up / sender assembly to find the brass float had a hole in it. Repaired the...
Drained the tank and repaired a leaking float for the fuel gauge.
With the short yoke on the 9", the stock drive shaft should work.....mine did.
My Taurus fan swap was done with the battery in the trunk but connected to the solenoid in it's stock location up front.
I run the HO cam with 1.7 RRs in my heavy Cougar and it works very well.
If it's got traction, there is no need.
I went through this extensively with the local OPP here in Simcoe. As it stands, if there are only lap belts, they can be used with booster seats...
You need to upgrade the alt due to the fact that the stock alt can barely keep up to running the lights, heater fan and a decent radio all at...
I contemplated the R&C when I started gathering info to do a 521 swap but lost interest when my health went. By all accounts, the R&C specked out...
Although I haven't done a 670 as of yet, I use these on all my VS carbs as well as some DPs and some I build for friends....
First of all," pretty don't make fast". Don't worry how the ultra looks because once the air cleaner is on, nobody cares how it looks. How far...
What happened? I've got ladders and have seen them run straight @ low 9s.
Those appear to be spacers for the rubber snubbers......see the threaded inserts?
With all due respect Dan, I have to disagree with the shackle suggestion. I never had to alter my shackles to get my bars to work properly. I...
Phil. I just re-read your post (and signature) and realized this is more than just a simple cruiser. I assume you're using a 9". Have you tried a...
Those are a POS style bar. Take them OFF. Your noise will stop. As far as the usefulness of slapper bars, Grumpy Jenkins was running low 10s with...
The ideal spot is to have the snubber directly under the eye of the spring. You say yours are a couple of inches short. You will see no difference...
IF you can find an old 60s Econoline van, they came with 4.10s in a heavy 8" case. Just sayin....
I have both (Holley and Edelbrock) and I still prefer a Holley.
Separate names with a comma.
