Everett, the joint attached to the box is the wrong spline size. Came with the box, and was obviously mislabeled. As the deal for the oil cooler...
Everything is back together on the driver side! Removed the valve cover for installation, and replaced the seal while I was at it: [IMG]...
So here's one step forward, the pulleys are all in place and lining up good: [IMG] The downside: The Borgeson pressure hose is stuck right...
Funny enough - I went through my old pictures. I installed the ill-fitting Hooker Headers in June 2011. Only took me a mere 10 years to get it right!
My firewall plate will need to clearanced roughly in the same area. I will try to move the steering box a little, even thought about slotting the...
Well, clearance was not as good as mentioned above - tightened the steering box today, it is very close to one of the pipes. May need some...
Well, now we are getting somewhere.... Here's the front end of the engine, water pump back on, as well as the original nice soup bowl of a crank...
Some of the Econoline folks have done, with great success. Pretty straightforward install, and the system itself is pretty much the same as the 2v...
this is not a hurst shifter, it's probably the stock shifter with a hurst boot. where's the slop? in the shifter handle itself? take the boot off,...
get a picture. what bushings are you referring to? the ones on the shift linkage? if so, a hurst „pit pack“ may be what you need.
try rockauto.com, they should have everything you need.
Here's the situation in the front: [IMG] Shroud and fan installed and wired, with the exception of ignition, I'll grab that off the coil. I put...
first bump in the road... that ebay deal for the complete pulley/ps kit fell through. i was able to source individual pieces, though. some here in...
@xpsnake, that is the setup i used - i just got the larger size master. the centerforce clutch is pretty stiff, so i might need all the force i...
The bellhousing and flywheel came with the old toploader. Probably came from a 351ci engine. Put a pricey Centerforce clutch on it. Can't see me...
Finally, I'll be working on the Comet again. It's on a lift for an assessment of the situation. Current plan of attack: Remove mechanical clutch...
I really like what you have done to the car so far!
Looking good! I'll have a thorough look at my car this weekend to see whether I need one.
lookin' good!
which cross over to the mustang and are readily availabe:...
Separate names with a comma.
