im gonna leave it like this. i like it way too much. it hu rts after about 30 minutes of driving but ill be ok. im smiling the entire time.lol
NOT an episode, but a Cold Start vid trying to pull in new viewers using key words. most dont use a choke in their vids, but i did. enjoy. also...
Probably a ridge worn inside the drum. Try to get that adjuster lloose
Ok tried it at 6 adv and dead zero. 6 made the rattle less and zero sounded the same as 6. ill stay with 6.
Ok ill back timing off to about 6 advance and see if that goes away. Just needed to be sure what i was hearing. Thanks.
So after experimenting between ported and full manifold vacuum, all i can say is WOW! Ive drove the car now for several weeks with ported and...
What gasket or o ring do i need to stop a big leak around my shifting levers on the stock 250 c4? And is it easy to change? Never done this. Its...
The c4 trans im using on my 302 is from a 250 engine. I also used the 250 convertor. Question is.... It shifts way to fast before rpms get up...
Its a new distributor and timing gear and chain. That why i was confused. So far though its staying in time.
So if it starts again does that mean the distributor may be bad?
I bet youre right. In paint school we used dawn soap mixed with water in a sprayer. We were always told to drench the area and to much spray was...
If you use a floor shifter trust me..... Bolt the main body of the shifter in before you put the trans in. I almost wasnt able to get 2 nuts...
Ill def check that tomorrow.
Yep thats it. I drove it 180 miles today and its the biggest test yet and it ran perfect the entire way. I checked timing eevery 50 miles and it...
Thanks. The valve covers is what does it for me.
So over the last few weeks ive been messing with my timing as some of you know but have noticed that the timing seems to go from perfect to...
ty. Ive found and can feel that no VA vs using VA on ported i can tell a good difference in take off. I can also tell a little difference in the...
Ok so now that ive got the 302 and drove it several tines now and messed with the vacuum advance and went from one extreme to the other, i...
Slow go as of late but im almost done. I got the rust flushed from the block and used the old radiator until all ran clean with waterhose as it...
Ty for the reply. Im not ignoring stumanchu's advice though. Im just thinking outloud and asking questions. I just noticed how the idle effects...
Separate names with a comma.
