Thanks! I'll give it a try!
Wow….it’s been almost two years… Long story short, life happens and my build plans have changed for this engine. At some point I may circle back...
Classic Inlines has some interesting information on the I6 exhaust systems. Kits like the “Arvinode Dual Exhaust” could provide some insight for...
Come on fella's, you know you watched Gilligan's Island and she was HOT back then!!! I'm more of a Maryann kind of guy but still!!!!!
Great minds think alike!!!!
I've put 32k on her, lots of fun but at some point I'd like to retire her daily duties!
Turned 100k today!!! Had to drive around the block twice but didn't want to miss the photo op!! [IMG]
Thanks Bryant! Sounds good, I'll check into it!
Don't know?? I was just searching for a v-belt pulley with a shaft diameter 17 millimeters or .669in. inside diameter with an outside diameter of...
My regulator has been replaced at some point, it’s not the original. My idle speed is set at approximately 480 rpm. At that speed, the alternator...
Dim dash lights… Yah, I know this has been covered a billion and one times and there are many solutions but I did find some interesting facts I...
Yep, found it. That little brass fitting in the fluid should not have that ring nest to the inside diameter, it should be smooth. Needs to be...
After some more research, there’s a common problem with some of the rebuilt steering boxes. The rebuilders don’t put new brass seats in the...
I have 1973 F250 that I need a little help on, it’s a two wheel drive model that’s pretty much stock. Anyway, need some advice on sealing the...
I'll likely go again this year, been focused on other things lately but definitely want to go!
Looks like SCCA Solo runs lot's of dates next year, I remember when they only ran a few times a year! http://sdrscca.com/solo-schedule/
Subscribed!! Boy o’ boy, don’t log in for a few weeks and the world changes! Looking forward to the progress on “your” Maverick!!!
That's the worst luck... On the bright side, you just saved yourself later down the road!
The uniformity of the edge and the downward angle into the engine bay all the way around looks like something a factory would have done. My guess...
I just pulled a Holley 4160 out of the wreckers, no telling how long it was sitting out there. Found spiders in the float bowl, clogged...
Separate names with a comma.
