I spoke to that guy at the Good Guys show in October. There was not much of the car that was original, but it was impressive.
My understanding is that there is 1 manufacturer and many vendors.
You could change the filler neck.
You need a transmission mount. The 2 studs go through the elongated holes on the cross member. The 2 outside elongated holes on the mount have...
Drew, where did you get that weatherstrip for the hood and air cleaner?
Do it the way the factory did. The filter sits higher in the air cleaner base. If water enters the air cleaner it sits in the bottom of the air...
The 71 - 73 Mustang bucket is the same, but you need Maverick/Comet bucket seat tracks or good fab skills to modify/make some. You can make...
If you have been playing around with the switch, check the fuse. I believe there is one specifically for the instrument lights. It is the...
Make sure you do not throw away the windshield stands!
I have a set, but shipping from Dallas would not be worth it.
It is a large o-ring that is squared on the edges. [IMG]
I must say, I got a little teary eyed.
Yes.
All Mavericks/Comets I have seen are staggered with right front and left behind. If 69 did not have staggered, Ford typically mounted the rear...
Yes, Yes, and No.
Mine is different than the one you and Hotrock show. It must be a in between design. It has the rear water cross over and provisions for 2...
I had one of those brackets on the Mustang, and it did pull the two rivnuts loose from the frame. Lowering the slave piston applies more leverage...
I actually need front and rear upholstery and wanted to add the buttons to that.
Are these seat buttons the same ones used on Mustangs, or are they reproduced?[IMG]
This is a picture of the Ford Granda split bench, it looks to be what you have. If you can get some Maverick tracks it would probably bolt up. [IMG]
Separate names with a comma.
