Always best change and keep the same type spark plugs all at once and not mix/match........ spark plugs should not have anything to do with engine...
I do not know how much for OEM oil sensor, but the only way to really know what your oil pressure reading is to use a gauge. Even if you go to...
So did you go for an aftermarket analog or mechanical temp gauge? If so, you might as well get matching aftermarket oil gauge, at least both will...
This is what I've used back in the late 80's early 90's to monitor air/fuel and tuning.......
The link I sent you was for a "mechanical" temp. gauge, so hole required would be slightly larger than if you where using an "electrical" gauge....
https://www.summitracing.com/int/parts/sww-82326-60/overview/ David
Alignment spec's: http://opentrackerracing.com/technical/ David
Have you checked/replaced any of the other front suspension parts, tie rods, idler arm, ball joints etc.? What about wheel alignment too? Just...
I never had to add any lube/grease, as steering box was full, only had to adjust to take up some play, so it never got to a point of making...
http://www.stangerssite.com/lubrication.html David
There should be a small filler/breather nut on top side in which you can fill with lube, not sure what grade, but you can contact these folks:...
Here is link to eBay for Control Valve rebuild kit:...
Where is the nut securing the ball stud to pitman arm or did you take it off? David
Here is link for pair on eBay:...
Hi Frank: These are the ones I have and they are bright! http://www.discountfleetsupply.com/tlc27270c-p.html The 27250 series is 1st generation...
You have a 8 inch rear, quickest and easiest way to tell, if you can use a socket on all 10 nuts, it is 8 inch, on the 9 inch the bottom 2 nuts...
Do you have an Industrial Foam Shop in your area? They will have all sorts of different foam products and I am sure they can match up type etc.,...
That is too bad, I guess there is not enough demand for them to make? I suppose you could go to a foam shop and purchase a piece of foam similar...
Have you tried contacting these folks? They make all kinds of gaskets for our Mav/Comet......... or I am sure they can fabricate a new one, said...
Try contacting member JOEXR793 David
Separate names with a comma.
