So, you drive around at 100 mph often ?
Finally someone who thinks the way I do. How many members here actually drive their cars everyday ?
You can adapt the newer stainless lines found in the J'yards off the late model picks and vans for this too. I did this on mine using a set of...
It's not hard to do but you'll definitely need a spring compressor. And be extremely careful with that as a suddenly released coil spring can be...
I wouldn't brush it off without checking it out. More than once I've checked out vehicles like this that had perfectly good engines in them or...
May have blown a head gasket. That's more likely than a cracked head. Really depends on how long it ran hot and low on coolant. First thing off,...
I've run Hookers on a big block Stang. They were a POS header. Same problems as listed here. I'll take the "cheaper" Hedmans. As for the driver's...
What "big block" toploader are you referring to ? Not a 390 unit is it ?
Damned glad I didn't buy Hookers. None of these problems with Hedman's.
That transmission in the van could well be an FMX, not a C6. FMX will fit in a Mav. Little harder to get parts for but they were tougher...
Yea, I might have to do that as well.
The 92 Cougar motor has everything the same internally compared to the Stang HO motor. The 93's had the GT40 roller cam. Pickups got roller cams...
No, this is the old style that the car came with. The quality of the current production is clearly not up to par with the originals. Used to be if...
Those will fit. The Vic Jr's problem is the carb pad isn't canted to compensate for the engine's installed angle, like most other intakes, making...
Even on a drag car, a carb doesn't need that kind of pressure in the fuel pump.
Stainless into aluminum ? Always use antiseize on the threads (and shanks) . Matter of fact, always use it regardless of the bolt material into...
Yea, gotta be careful draining a gas tank in an enclosed garage that has a working hot water heater in it.
About the only thing that won't fit is a Parker funnel web. I ran my 3x2 setup under the hood before adding spacers and a 3-1/2" K&N to it after...
A combination joint has one side that fits the driveshaft, the other cups fit the differential yoke. (or transmission slip yoke)
I'm not familiar with the Edelbrock carbs, but the distributor hose needs to be connected to a vacuum port on the carb that only sees vacuum when...
Separate names with a comma.
