Anyone going to attend the race in Memphis at the end of this month? May run down to watch, 23 & 24th I believe.
Interesting, I have run all the cases made for the 8in(which I figured was only one) with 302's, up to 351W's. 9in to 10 1/2in slicks, and never...
If you have a 302 as you describe, keep the 8in and beat on it all you want. Without a turbo etc. or NOS or std. tranny sliding the foot off the...
There is little quality control in anything made in China, but some people still buy the crap cause it is cheap, then end up buying another item...
Guess I have been doing it wrong for the last fifty years, never to old to learn though. Compression test is only a guide line to cylinder...
Roy, did you call MSD about your old one? They will give you a PO number and you can ship it back to them for repair at a nominal charge....
If it not the pump shaft, spin it with a primer rod and see if the pump is ok. Are you running the steel push in oil galley plugs, in the front of...
Found these on early Ford van's with 460 engine's. May be other application's too. The remote one's just never appealled to me with those hoses....
Decided to make a pass or two being the weather was so nice and wanted to get the Fairmont up to the track so I could have the trailer empty to...
Removed the handles and lock assy, then welded up the holes. Some final bondo work and that's it. Being this is strictly a race car, the interior...
Almost ready for final paint on Mavman's racing machine.
It is not an easy job for the inexperienced. Some say you have to remove the windshield and rear glass to do it. Way back when I had my 75, I took...
You need to have a good rebuild on the trans. This includes a five disc foward clutch set-up as stated earlier. No need for a full blown race prep...
Have had several aftermarket flex plate's with same problem. Quality control is not alway's a factor in some mfg. plant's oversea's. If you...
I have not used that type but have used other's. depending on cam, heads, and other factors, some work and some hinder. MPH gains is what I found...
I have used Eagle kit's that were about the same price as your first post. If you use I beam rods, the block will not have to be clearanced, only...
Just a little tip on your project, after removing the trans, loosen the front band adjuster nut and run the screw in tight. This will hold the...
Nope, none of our cars are street legal and they must also be 93 or newer, FI. The way I was told, is the participants will all bring their cars...
Hey Don, could you see it in your plans, to send a little warm temps, this way. Been there, done that, with the pushing in lights deal. Just for...
Is not that bad to do if you have a dial indicator and pair of dial calipers or depth gage. Helps to have a big vise to hold the housing after it...
Separate names with a comma.
