I put a Maverick hood and Charlie Yan's billet grill on my Comet today. It fits nicely. It's nice to be able t just order parts and they bolt in...
Ok, Thanks for the response.
I ran 225/40/17 and 245/40/17 on a 17x8 rim with a 4 1/2" backspace. It fits as long as the top of the tire is not tucked inside the fenders. When...
Dave B is correct. I have 12" wide rears and the leafs and frame was in the way. But if you flare the wheel well, it may barely fit depending on...
I have never seen a manual transmission car with a transmission temp gauge. I swapped the C4 to a T5. Can I used the trans temp gauge with the T5?...
Thanks. I guess I will order the leafs with a 2" drop. I knew stock would be to tall for the rear. My tire is 26" and its seems that the driver's...
Wow, that is low. Thanks
What's the measurement after you install the new leafs? Did you get any de-arching?
I have been trying to figure out how much my leaf springs have came down from stock. I need to order knew leafs and I need to have them de-arched...
Ok thanks. I guess this will work if the base line is considered the ground.
I need some measurements from a stock suspension with stock tire size Maverick/Comet. I need to know how many inches from the center rear wheel...
Frank, that's in the block
Thanks!!!!! Your eye sight is great.
I have a Taurus fan. It is really close to the water pump pulley. I have a March pulley system, so i cant say for sure it will fit the stock...
Try an adjustable proportion valve. I don't know if on the front or rear. I'm not that knowledgeable about brakes yet.
Yes, the block is from a 92 Mustang. I used a gasket. There is no leaking between the block and intake.
The oil pressure unit is in between the oil filter and fuel pump. It's on the lower part of the block on the driver's side. Unless it has two places.
There is a threaded whole on top of the block, on the passenger side rear. What is it there for? What thread size? Do I need to plug it? I been...
Ok , thanks gentlemen. ':agreed::agreed:
Where did you get the fire wall feed connector? That seems to clean up the large factory harness nicely.
Separate names with a comma.
