Tail lights? I had the car completely down and when I finished putting it together I had no tail lights the bright light indicator was on and the...
Do you just torch the collar?
I can't seem to press these things off. I have a little 12 ton press but no good way to set it up. I had to remove the heavy press surface and...
Sure sure..sure...but it's stuck on...I put my jack on it and the rear of the car is off the jack stands only supported buy the center...
Does any one have tips for seperating the carier once axels and related bolts are removed?
since I no longer have the small car with the e-brake that you can get you sideways through a turn I switched to a distribution block, and with...
Try this Start out with a little less clutch... just don't let it break loose in the first place...this is hard to do with cheap tires (I know)....
well... I ran another wire for the map lights. I used a slightly heavier gauge wire to make it possible to fish the wire through my head liner....
yea... I did this one! No and no. You'll need another hot wire for the map lights and it can't be spliced from the one that is there because...
yea I was using one from a 68 cougar untill I broke it
N/M oops
not much motor mounts/frame to motor mounts and a cross member if you like. v-8 throttle linkage. that's all folks.
that depends It might not matter but it depends on which water pump your going to run. Like I said it might not matter. Just, what over all set...
say? What are thoes mirrors from?? Did you paint thoes chrome?
DELETE MESSAGE You can delete this. I just put it back! Thanks, JC
right on I guess the mach 1 spoiler can stay since it's vintage. If you arn't going stock I could see removing the rear bumper guards too....
looks clean What are your plans? I would lose the fog lights, side pipes and rear spoiler. Nice car though!
I took on the task of rebuilding a friend carb....this is really dumb but I forgot a wee little spring. On the main metering rods there is a...
? stefan....are you a lawyer? -just kidding
I made mine from PVC plastic but I left it on it's side in the sun on day. I then made another from diamond plate aluminum....turnd out to be too...
Separate names with a comma.
