On a clearanced race motor I've run a high preasure,on my "street" motors I run a Good standard pump,but I have found a high volume will just fill...
Thanks Razor.
Worked on the car today,pulled the column to convert to the Must II susp.,installed my clutch pedals,removed dash pad,an cleaned up some...
I ran a stock dist. with electronic conversion with my Offy Tunnel ram,had to be real careful where the vac.diaf.ended up so you could set...
Will,I just did 2 Must II fronts,my own Mav. and a customers,I am just starting to figure out steering shaft out of stock columun to rack with...
I remember seeing his Mustang run somewhere years ago with a similar paint scheme,he ran really well if I remember correctly,was SS champ one year...
Run a .30 over 351w with Ross lightweights in our circle track car,stock rods ARP rod bolts,balanced,turned it 6200-6500 rpm for two seasons never...
Well I've had close to 100 Fords over the years and if there is one thing I've learned about them is they are always consistent and do it the same...
scooper...was this your car to start with?(I wasn't around then)If it was ,thats a great transformation happening.
'73-'79 F-150,I can get a part # if you need it.
I finished the tub part of this project today,tubs and floor are done,aligned everything for a final time,brakes are all finished,I like to use...
Joe,Happy Birthday..God Bless!Get well soon.
Correct..well said.
A few months back I stripped a "85 Bronco for the 351,it was a 4 speed truck,saved the hyd.setup for some other project,nice and simple(outside...
A good all round street strip posi thats not too" clunky" or jerky for the 8" or "9 is a repoduction of the Ford Trac-Loc called a Duragrip,sold...
Somewere way back in this thread I noted that I like to leave the stock rails in until cage and everything was welded in to keep the body from...
Actually it's Blackhawk Frame bench from the mid '80s,you would rent fixtures from Blackhawk for each specific make and model when repairing frame...
My customer wants to race it this summer,the motors done and I should have the Must II and motor mounts in within a couple weeks,I"ll see if he'd...
Heres an update on the Maverick project,the rear is narrowed,and the 4 link and diagnoal are installed,with the coilovers,The axles came in Fri....
I know I'm a little older than some of you but being that I saw these two run in a match race...when they were "new"does that make me old?Sunset...
Separate names with a comma.
