If your timing light is a dial-back type I would suspect that before the tach.
There's no crossmember, just a pair of angle brackets that bolt to the sheet metal under the forward section of the trunk. At least that's how it...
If I can find mine you can have it for the cost of shipping.
Do you have photos of your rusted areas?
I think he should do a 347 stroker with aluminum heads, 300* duration cam, single plane intake, 750 double pumper, 1 3/4" headers w/3" exhaust,...
Tremec bought the T5 line from Borg Warner in the mid-90's. I bought mine new in '96 from a Borg Warner distributor and it came in a Tremec box....
That's how I have mine held on.
https://www.summitracing.com/parts/sum-3600/overview/make/ford Same cam that Edelbrock sells as their Performer + but less than half the price.
Just get rid of the distributor and go EDIS...
I ran my T5Z behind a nitroused 347 for a few years without problems. The tires spin before you hurt the trans. But I also wouldn't recommend...
You can move the solenoid down low in the engine compartment where it's less noticeable. I mounted mine at the lower hole for the battery tray....
I've never had a Duraspark and it doesn't look like the OP does either. IIRC, you just need to disconnect the white wire from the Duraspark and...
One way I've used on non-stock engines to find how much initial advance they like is to warm up the engine, advance 2*, shut down and let the...
The charge cable has to connect to the hot side of the solenoid, the starter connects to the switched side. Maybe I'm misunderstanding you?
The book says 6* BTDC for your engine but I would probably give it 10 or 12 degrees advance.
Why do you want to move the solenoid to the trunk? The charge wire from the alternator and the two small solenoid wires would have to run all the...
Wouldn't happen to be Ed Curtis would it?
Float level would be my guess. Fuel expands some when it gets hot. Also readjust the idle mixture when the engine is warmed up.
The UCA bushings get torqued on the bench before you install in the car. You do have to make sure the shafts are centered. What brand ball joint?...
My 70 2-door came with them. There's been some debate whether they were factory or dealer installed. I just know that I didn't install them and...
Separate names with a comma.
