Posted by: Ken Merring ®
2001/09/28, 21:50:30
Author Profile
|
... I think there is confusion setting in about your problem.
..Does the engine seem to run normal in neutral,,rev ok etc? If so. Put in drive ,is there a hard clunk? Go from drive to reverse is there a clunk? If so then the U joint/s are flopping around in the drive shaft. The needle bearings are gone out of the caps. This will cause all kinds of carryon. There could still be other problems like ring and pinion but get under and take a look.
..C4 trans does not use vaccum functions until up shifting or down shifting needs to occurr in the drive selector position. In first or second you have manuel control of the function. There is also a centrifical shifting control, in the trans that is speed sensitive, to control shifting. I'm hoping its only U joints.
Good luck, Ken
|
